Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010, Configuration Manual

Page: 601 / 774

Figure 55: Assigning a Profile to a Static Interface
Configuring a Profile
You can create a profile by using CLI commands similar to those used to create the
equivalent static interfaces. You can configure a profile for bridged Ethernet, IP, IPv6,
MLPPP, PPP, PPPoE, or VLAN interfaces.
To configure a profile:
1.
Create a profile by assigning it a name.
host1(config)# profile foo
2.
Specify a VR to which to assign dynamic IP interfaces created with this profile.
host1(config-profile)# ip virtual-router egypt
3.
Specify an IP loopback interface for dynamic IP interfaces created with this
profile to be associated.
host1(config-profile)# ip unnumbered loopback 0
4.
Configure IPCP option 0x90.
host1(config-profile)# ppp ipcp netmask
5.
Optionally set IP, IPv6, MLPPP, PPP, or PPPoE characteristics.
NOTE: When configuring either IP or IPv6 to operate over PPP, you might want to
initiate IP or IPv6 by using the appropriate ppp initiate command, either ppp
initiate-ip or ppp initiate-ipv6 . This command initiates either IPv4 or IPv6 in the
event you are connecting to a passive client.
bridge1483 mtu
Configuring a Dynamic Interface from a Profile
■ 569
Chapter 17: Configuring Dynamic Interfaces