Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010, Configuration Manual

Page: 487 / 774

host1(config)# pppoe subinterface atm 4/0.101.2.1
5.
Specify PPP as the encapsulation method on the interface.
host1(config-subif)# encapsulation ppp
6.
Assign an IP address and mask to the interface.
host1(config-subif)# ip address 10.1.1.2 255.255.255.0
Configuring MPLS over VLAN
To configure MPLS over VLAN over a bridged Ethernet interface:
1.
Follow the steps in “Configuring VLAN Subinterfaces over Bridged Ethernet” on
page 453 to configure the VLAN subinterface.
2.
Enable MPLS on the VLAN subinterface.
host1(config-subif)# mpls
atm pvc
Use to configure a PVC on an ATM interface. Specify one of the following
encapsulation types:
■
■
aal5snap —Specifies a logical link control (LLC) encapsulated circuit;
LLC/Subnetwork Access Protocol (LLC/SNAP) header precedes the protocol
datagram.
■
aal5mux ip —Specifies a VC multiplexed circuit. This option is used for IP
only.
■
Example
host1(config-subif)# atm pvc 1 5 50 aal5snap 0 0 0
■
Use the no version to remove the specified PVC.
■
See atm pvc.
encapsulation bridge1483
■
Use to configure bridged Ethernet as the encapsulation method on an ATM 1483
subinterface.
■
Example
host1(config-subif)# encapsulation bridge1483
■
Use the no version to remove bridged Ethernet as the encapsulation method on
the interface.
■
See encapsulation bridge1483.
encapsulation ppp
Configuring VLANs over Bridged Ethernet
■ 455
Chapter 14: Configuring Bridged Ethernet