Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010, Configuration Manual

Page: 489 / 774

host1(config-subif)# ip address 10.1.2.3 255.255.255.255
■
Use the no version to remove the IP address.
■
See ip address.
mpls
■
Use to enable, disable, or delete MPLS on an interface. MPLS is disabled by
default.
■
Example
host1(config)# mpls
■
Use the no version to halt MPLS on the interface and delete the MPLS interface
configuration.
■
See mpls.
pppoe
■
Use to create a PPPoE major interface.
■
Example
host1(config-subif)# pppoe
■
Use the no version to remove the PPPoE major interface.
■
See pppoe.
pppoe subinterface atm
■
Use to create a PPPoE subinterface over a VLAN subinterface configured on a
bridged Ethernet interface.
■
On ERX7xx models, ERX14xx models, and the ERX310 router, use the
slot/port.atmSubinterface.vlanSubinterface.pppoeSubinterface format.
■
On E120 and E320 routers, use the
slot/adapter/port.atmSubinterface.vlanSubinterface.pppoeSubinterface format.
■
Examples
host1(config)# pppoe subinterface atm 4/0.1.2.1
host1(config)# pppoe subinterface atm 4/1/0.1.2.1
■
Use the no version to remove the PPPoE subinterface.
■
See pppoe subinterface.
vlan id
■
Use to specify the VLAN ID.
■
Use a VLAN ID that is in the range 0–4095 and is unique within the interface.
■
Issue the vlan id command before any upper bindings are made, such as IP or
PPPoE.
Configuring VLANs over Bridged Ethernet
■ 457
Chapter 14: Configuring Bridged Ethernet