Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010, Configuration Manual

Page: 415 / 774

Table 21: Interface Specifier Format Examples for dsl-forum-1 Keyword (continued)
Format of
dslForum1InterfaceSpecifier
How Router Translates Internal Router Format Interface Example
eth 2/0/0:4096.4096
■
Sets adapter to 0
■
Sets both svlanId and
vlanId to 4096
■
Uses other values as
supplied
gigabitEthernet 2/0 Gigabit Ethernet interface on
slot 2, port 0 with no VLAN
or S-VLAN subinterfaces
eth 4/1/1:4096.4096
■
Sets both svlanId and
vlanId to 4096
■
Uses other values as
supplied
gigabitEthernet 4/1/1 Gigabit Ethernet interface on
slot 4, adapter 1, port 1 with
no VLAN or S-VLAN
subinterfaces
eth 2/0/0:4096.5
■
Sets adapter to 0
■
Ignores subinterface 1
■
Sets svlanId to 4096
■
Uses other values as
supplied
gigabitEthernet 2/0.1:5 Gigabit Ethernet interface on
slot 2, port 0, subinterface 1
with VLAN ID 5
eth 4/1/1:4096.10
■
Ignores subinterface 3
■
Sets svlanId to 4096
■
Uses other values as
supplied
gigabitEthernet 4/1/1.3:10 Gigabit Ethernet interface on
slot 4, adapter 1, port 1,
subinterface 3 with VLAN
ID 10
eth 2/0/0:5.6
■
Sets adapter to 0
■
Ignores subinterface 1
■
Replaces - (hyphen)
between
svlanId and
vlanID with . (period)
■
Uses other values as
supplied
gigabitEthernet 2/0.1:5-6 Gigabit Ethernet interface on
slot 2, port 0, subinterface 1
with S-VLAN ID 5 and VLAN
ID 6
eth 4/1/1:10.20
■
Ignores subinterface 3
■
Replaces - (hyphen)
between
svlanId and
vlanID with . (period)
■
Uses other values as
supplied
gigabitEthernet 4/1/1.3:10-20 Gigabit Ethernet interface on
slot 4, adapter 1, port 1,
subinterface 3 with S-VLAN
ID 10 and VLAN ID 20
Use by RADIUS or L2TP
Enabling the router to capture and format the PPPoE remote circuit ID sent from the
DSLAM has no effect by itself. To use the PPPoE remote circuit ID value, you must
send it to a RADIUS server, to an L2TP network server (LNS), or to both by doing
one or more of the following:
■
Issue the radius override calling-station-id remote-circuit-id command to
substitute the remote circuit ID value for the standard Calling-Station-Id [31]
RADIUS attribute.
Overview
■ 383
Chapter 12: Configuring Point-to-Point Protocol over Ethernet