Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010, Configuration Manual

Page: 325 / 774

■
peer-secondary-dns-address—IP address to be used in negotiation of
the peer secondary DNS address
■
peer-primary-wins-address—IP address to be used in negotiation of the
peer primary WINS address
■
peer-secondary-wins-address—IP address to be used in negotiation of
the peer secondary WINS address
NOTE: The command displays the authentication status as “none” for any parameters
not provided by the authentication server.
■
peer-ipv6–interface-id—IPv6 interface Identifier of the peer returned in
an authentication grant from the RADIUS server
■
Authentication statistics—Shows statistics accumulated since the session
was established
■
up-time—Time the session has been up, in seconds
■
in-octets—Number of octets received on the interface
■
out-octets—Number of octets transmitted out the interface
■
in-packets—Number of packets received on the interface
■
out-packets—Number of packets transmitted out the interface
■
PAP protocol configuration
■
request-timeout—Maximum time, in seconds, to wait for an
authentication request packet
■
CHAP protocol configuration
■
name—Name to be used in challenge packets
■
challenge-retry—Maximum number of challenge packets to be
transmitted
■
challenge-timeout—Frequency, in seconds, of challenge packet
retransmission
■
minimum-challenge-length—Minimum length of challenge packet
■
maximum-challenge-length—Maximum length of challenge packet; the
size of the challenge used for each challenge packet is a random number
between minimum-challenge-length and maximum-challenge-length
■
minimum-rechallenge-timeout—Minimum time, in seconds, before
initiating a rechallenge to peer
■
maximum-rechallenge-timeout—Maximum time, in seconds, before
initiating a rechallenge to peer; the actual time before a rechallenge is
a random number between minimum-rechallenge-timeout and
maximum-rechallenge-timeout
Monitoring PPP Interfaces
■ 293
Chapter 8: Configuring Point-to-Point Protocol