Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010, Configuration Manual

Page: 261 / 774

■
Ethernet OAM Link-Fault Management Platform Considerations on page 229
■
Ethernet OAM Link-Fault Management References on page 230
Ethernet OAM Link-Fault Management Platform Considerations
You can configure 802.3ah link-fault management on the following E Series routers:
■
E120 router
■
E320 router
■
ERX1440 router
■
ERX1410 router
■
ERX710 router
■
ERX705 router
■
ERX310 router
Module Requirements
For information about the modules that support 802.3ah link-fault management on
ERX14xx models, ERX7xx models, and the ERX310 router:
■
See ERX Module Guide, Table 1, Module Combinations for detailed module
specifications.
■
See ERX Module Guide, Appendix A, Module Protocol Support for information about
the modules that support 802.3ah link-fault management.
For information about the modules that support 802.3ah link-fault management on
the E120 and E320 routers:
■
See E120 and E320 Module Guide, Table 1, Modules and IOAs for detailed module
specifications.
■
See E120 and E320 Module Guide, Appendix A, IOA Protocol Support for information
about the modules that support 802.3ah link-fault management.
Interface Specifiers
The configuration task examples in this chapter use the format for ERX7xx models,
ERX14xx models, and the ERX310 router to specify 802.3ah link-fault management
For example, the following command specifies a Gigabit Ethernet interface on port
0 of an I/O module in slot 4.
host1(config)# interface gigabitEthernet 4/0
When you configure a Gigabit Ethernet interface or a 10-Gigabit Ethernet interface
on E120 or E320 routers, you must include the adapter identifier as part of the
Ethernet OAM Link-Fault Management Platform Considerations
■ 229
Chapter 7: Configuring IEEE 802.3ah OAM Link-Fault Management