Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010, Configuration Manual

Page: 57 / 774

■
Set the administrative state of an ATM AAL5 interface to disabled.
host1(config-if)# atm aal5 shutdown
■
Enable CAC on the interface.
host1(config-if)# atm cac 3000000 ubr 3000
■
Configure the clock source.
host1(config-if)# atm clock internal
■
Configure framing on a T3/E3 physical interface.
host1(config-if)# atm framing g751adm
■
Enable ILMI on the interface.
host1(config-if)# atm ilmi-enable
■
Set the ILMI keepalive timer.
host1(config-if)# atm ilmi-keepalive 5
■
Specify the cable length (line build-out) for the ATM interface.
host1(config-if)# atm lbo long
■
Set the administrative state of the ATM interface to disabled.
host1(config-if)# atm shutdown
■
Configure SNMP link status traps on the interface.
host1(config-if)# atm snmp trap link-status
host1(config-if)# atm aal5 snmp trap link-status
■
Set the operational mode of the physical interface to SDH STM1.
host1(config-if)# atm sonet stm-1
■
Configure the UNI version of ILMI using one of the following methods:
■
Enable auto configuration of ILMI.
host1(config-if)# atm auto-configuration
■
Set the UNI version that the router uses when ILMI link autodetermination
is unsuccessful or ILMI is disabled.
host1(config-if)# atm uni-version 4.0
■
Configure the number of virtual circuits for each virtual path.
host1(config-if)# atm vc-per-vp 128
■
Configure a virtual path tunnel and its traffic parameters.
Setting Optional Parameters
■ 25
Chapter 1: Configuring ATM