Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010, Configuration Manual

Page: 421 / 774

■
Example
host1(config-if)# pppoe max-session-vsa override
■
Use the no version to restore the default behavior, ignore.
■
See pppoe max-session-vsa.
Figure 38 on page 389 illustrates the interface stack for this configuration.
Figure 38: Example of PPPoE over ATM Stacking
atm pvc
■
Use to configure a PVC on an ATM interface.
■
The following parameters are mandatory:
■
vcd —Virtual circuit descriptor, which identifies a virtual circuit in the range
1–2147483647. The vcd is a unique number that you assign, which identifies
a virtual circuit. The vcd value has no relationship to the vpi and vci values
and has meaning only to the E Series router.
■
vpi—Virtual path identifier of the PVC. The VPI is an 8-bit field in the ATM
cell header. The VPI value is unique on a single link, not throughout the ATM
network, because it has meaning only to the E Series router. The VPI value
must match the value on the switch. The parameters vpi and vci cannot be
both set to 0; if one is 0, the other cannot be 0.
■
vci —Virtual channel identifier. The VCI is a 16-bit field in the ATM cell
header. The VCI value is unique on a single link, not throughout the ATM
network, because it has meaning only to the E Series router. The parameters
vpi and vci cannot be both set to 0; if one is 0, the other cannot be 0.
■
encapsulation type:
Configuring PPPoE over ATM
■ 389
Chapter 12: Configuring Point-to-Point Protocol over Ethernet