Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010, Configuration Manual

Page: 591 / 774

5.
Assign a profile to match the encapsulation type of bridged Ethernet.
host1(config-subif)# profile bridgedEthernet foo
6.
(Optional) Assign subscriber identification.
host1(config-subif)# subscriber bridgedEthernet user charlie domain myisp
password lucy
7.
(Optional) Verify your configuration.
host1# show atm subinterface atm 2/0.1
atm pvc
Use to configure a PVC on an ATM interface. Select one of the following
encapsulation types:
■
■
aal5autoconfig —Enables autodetection of the 1483 encapsulation (LLC/SNAP
or VC multiplexed).
■
aal5snap —Specifies a LLC encapsulated circuit; the LLC/SNAP header
precedes the protocol datagram.
■
aal5mux ip —Specifies a VC multiplexed circuit. This option is used for IP
only.
■
Example
host1(config-subif)# atm pvc 6 0 11 aal5autoconfig
■
Use the no version to remove the specified PVC.
■
See atm pvc.
auto-configure
■
Use to configure an ATM subinterface to support a dynamic interface. Specifies
the types of dynamic encapsulation that the ATM 1483 subinterface detects and
accepts.
■
For detailed information about how to use this command, see “auto-configure”
on page 531.
■
Example 1—Enables autodetection for the bridged Ethernet encapsulation type
using the default lockout time range, 1–300 seconds
host1(config-subif)# auto-configure bridgedEthernet
■
Example 2—Enables autodetection for the bridged Ethernet encapsulation type
using a nondefault lockout time range of 3600–21600 seconds (1–6 hours)
host1(config-subif)# auto-configure bridgedEthernet lockout-time 3600 21600
■
Example 3—Disables encapsulation type lockout for the bridged Ethernet
encapsulation type
host1(config-subif)# auto-configure bridgedEthernet lockout-time none
Configuring Bridged Ethernet Dynamic Interfaces
■ 559
Chapter 17: Configuring Dynamic Interfaces