Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010, Configuration Manual

Page: 690 / 774

■
Use to configure a PVC on an ATM interface.
■
Specify the VCD, the VPI, the VCI, and the encapsulation type. For more
information about these parameters, see “Creating a Basic Configuration” on
page 22 in “Configuring ATM” on page 3.
■
You can create a PVC within an existing bulk-configured VC subrange, or a
bulk-configured VC subrange that includes the VPI and VCI values of an existing
PVC.
■
Use the aal0 encapsulation keyword to cause the router to receive raw ATM cells
on this circuit and to forward the cells without performing AAL5 packet
reassembly.
■
Example
host1(config-subif)# atm pvc 10 100 22 aal0
■
Use the no version to remove the specified PVC.
■
See atm pvc.
interface atm
■
Use to select an ATM interface or ATM 1483 subinterface.
■
For information about specifying the ATM interface or subinterface, see “interface
atm” on page 645.
■
Examples
host1(config)# interface atm 5/0.1
host1(config)# interface atm 4/0/2
■
Use the no version to remove the interface or subinterface.
■
See interface atm.
mpls-relay
■
Use to route layer 2 traffic to the specified router.
■
For detailed information about using the mpls-relay command, see chapter
Configuring Layer 2 Services over MPLS in JUNOSe BGP and MPLS Configuration
Guide .
■
Example
host1(config-if)# mpls-relay 10.10.100.2 45
■
Use the no version to negate this command.
■
See mpls-relay.
Configuring VLAN Dynamic Subinterfaces
E Series routers support configuration of dynamic VLAN subinterfaces over static
VLAN major interfaces over Ethernet.
658 ■
Configuring VLAN Dynamic Subinterfaces
JUNOSe 11.1.x Link Layer Configuration Guide