Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010, Configuration Manual

Page: 720 / 774

host1(config-if)# vlan id 201 mac-address 0090.1a01.1234
4.
Create a bulk-configured VLAN range that includes the VLAN ID of the previously
configured VLAN. In this example, the VLAN range 100–250 includes VLAN ID
201.
host1(config)# interface gigabitEthernet 3/1
host1(config-if)# vlan bulk-config test2 vlan-range 100 250
5.
To fully configure the VLAN subinterface, assign an IP address or make it
unnumbered.
host1(config-if)# ip unnumbered loopback 0
encapsulation vlan
■
Use to configure VLAN as the encapsulation method on an interface.
■
Issuing this command creates the VLAN major interface.
■
Example
host1(config-if)# encapsulation vlan
■
Use the no version to disable VLAN encapsulation on the interface.
■
See encapsulation vlan.
interface gigabitEthernet
interface tenGigabitEthernet
■
Use to select a Gigabit Ethernet interface or a 10-Gigabit Ethernet interface.
■
For information about specifying a Gigabit Ethernet or 10-Gigabit Ethernet
interface, see “interface gigabitEthernet” on page 673 and “interface
tenGigabitEthernet” on page 673.
■
Examples
host1(config)# interface gigabitEthernet 1/0
host1(config)# interface gigabitEthernet 4/0/1
host1(config)# interface tenGigabitEthernet 4/0/1
■
Use the no version to remove IP from an interface.
■
See interface gigabitEthernet.
■
See interface tenGigabitEthernet.
ip unnumbered
■
Use to configure an unnumbered IP interface.
■
This command enables IP processing on an interface without assigning an explicit
IP address to the interface.
688 ■
Configuring VLAN Dynamic Subinterfaces
JUNOSe 11.1.x Link Layer Configuration Guide