Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010, Configuration Manual

Page: 117 / 774

■
interfaceSpecifier —Shows ping entries for this interface
■
vpi —Shows details of the last ping atm command on this VPI
■
vci —Shows details of the last ping atm command on this VCI
■
Field descriptions
■
Interface—Interface number
■
VPI—Virtual path identifier
■
VCI—Virtual channel identifier
■
CellCount—OAM loopback cell count configured on the interface
■
TimeOut—Timeout configured on the interface
■
SentCellCount—Number of loopback cells sent
■
RespCount—Number of loopback response cells received
■
Status—Status of the ping
■
Ping Cell Count—Cell count configured on the circuit
■
Ping Time Out—Timeout, in seconds, configured on the circuit
■
No Of Cells Sent—Number of ping cells sent on this circuit
■
No Of Response Received—Number of ping responses received on this circuit
■
Success Rate—Percentage of successful responses received for pings sent
■
round-trip min/max/avg—Minimum, maximum, and average time in
milliseconds that it took to receive responses to ping messages sent
■
Ping Status—Results of the ping operation
■
Ping Completed—Number of ping requests in the cell count were sent
■
Ping in Progress—Ping is in operation
■
Ping Not Started—Ping operation is not started; you may see this via
SNMP
■
Ping Stopped—Ping operation was manually stopped
■
Ping Stopped OAM Down— atm oam flush command was issued when
ping was enabled
■
ATM Interface Down—Ping operation is stopped as a result of interface
down operational status
■
OAM Flow Type—Segment, End-to-end
■
Example 1—Displays all entries in the router
host1# show atm ping
Interface VPI VCI CellCount TimeOut SentCellCount RespCount Status
Monitoring ATM
■ 85
Chapter 1: Configuring ATM