Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010, Configuration Manual

Page: 429 / 774

the EAP protocol. If the peer refuses to negotiate authentication, the router
terminates the PPP session.
■
Example 2—Configures EAP or CHAP or PAP on a dynamic PPP interface
host1(config)# profile ppptest
host1(config-profile)# ppp authentication eap chap pap
In this example, the router first attempts EAP negotiation. If PPP receives a NAK
from the peer in response to the EAP request, then the router attempts CHAP
negotiation. If PPP receives a NAK from the peer in response to the CHAP request,
then the router attempts PAP negotiation. If PAP is also rejected, then PPP
terminates the session.
■
Use the no version to specify that the router does not require authentication.
■
See ppp authentication.
pppoe
■
Use to specify PPPoE as the encapsulation method for the interface.
■
This command creates a PPPoE major interface.
■
Example
host1(config-if)# pppoe
■
Use the no version to remove the PPPoE major interface.
■
See pppoe.
vlan id
■
Use to specify the VLAN ID.
■
Use a VLAN ID that is in the range 0–4095 and is unique within the Ethernet
interface.
■
Examples
host1(config-if)# vlan id 400
host1(config-if)# vlan id 4 255 mac-address 0090.1a01.1234
■
There is no no version.
■
See vlan id.
Configuring PPPoE Without VLANs
To configure PPPoE over an Ethernet interface without VLANs:
1.
Specify a Fast Ethernet, Gigabit Ethernet, or 10-Gigabit Ethernet interface.
host1(config)# interface fastEthernet 4/1
2.
Specify PPPoE as the encapsulation method on the interface.
Configuring PPPoE for Ethernet Modules
■ 397
Chapter 12: Configuring Point-to-Point Protocol over Ethernet