Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010, Configuration Manual

Page: 649 / 774

■
Dynamic—VLAN or S-VLAN subinterface was configured dynamically
■
Auto configure interface(s)—Types of dynamic upper interfaces configured
with the
auto-configure command: IP or PPPoE
■
Detected dynamic interface—Type of dynamic upper interface detected
during autoconfiguration: IP, PPPoE, or (if no packet has been received)
none
■
Interface types in lockout—Encapsulation types currently experiencing
lockout: IP, PPPoE, or none
■
Lockout state (seconds)—Settings of encapsulation type lockout for the
upper-layer encapsulation type indicated
■
Min—Minimum lockout time, in seconds
■
Max—Maximum lockout time, in seconds
■
Current—Current lockout time, in seconds; displays 0 (zero) if lockout
is not occurring
■
Elapsed—Time elapsed into the lockout time, in seconds; displays 0
(zero) if lockout is not occurring
■
Next—Lockout time for the router to use for the next lockout event, in
seconds
■
In—Analysis of inbound traffic on this interface
■
Bytes—Number of bytes received on the VLAN or S-VLAN subinterface
■
Packets—Sum of all unicast, broadcast, and multicast packets received
on the VLAN or S-VLAN subinterface
■
Multicast—Number of multicast packets received on the VLAN or S-VLAN
subinterface
■
Broadcast—Number of broadcast packets received on the VLAN or
S-VLAN subinterface
■
Errors—Total number of errors in all received packets; some packets
might contain more than one error
■
Discards—Total number of discarded incoming packets
■
Out—Analysis of outbound traffic on this interface
■
Bytes—Number of bytes sent on the VLAN or S-VLAN subinterface
■
Packets—Number of packets sent on the VLAN or S-VLAN subinterface
■
Multicast—Number of multicast packets received on the VLAN or S-VLAN
subinterface
■
Broadcast—Number of broadcast packets received on the VLAN or
S-VLAN subinterface
Monitoring Upper-Layer Dynamic Interfaces and Profiles
■ 617
Chapter 17: Configuring Dynamic Interfaces