Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010, Configuration Manual

Page: 188 / 774

2.
Create an IP interface.
host1(config-if)# ip address 192.5.127.8 255.255.255.0
Figure 9 on page 156 illustrates this configuration.
Figure 9: Example of IP over Ethernet Stacking Configuration Procedure
Configuring PPPoE over a Static Ethernet Interface
To configure PPPoE over an Ethernet interface:
1.
Specify a Fast Ethernet, Gigabit Ethernet, or 10-Gigabit Ethernet port.
host1(config)# interface fastEthernet 4/1
2.
Specify PPPoE as the encapsulation method on the interface.
host1(config-if)# pppoe
3.
Create a PPPoE subinterface.
host1(config-if)# pppoe sub interface fastEthernet 4/1.1
4.
Specify PPP as the encapsulation method on the interface.
host1(config-if)# encapsulation ppp
5.
Assign an IP address and mask.
host1(config-if)# ip address 164.10.6.51 255.255.255.0
6.
(Optional) Configure additional PPPoE subinterfaces by completing Steps 3
through 5 using unique numbering.
Figure 10 on page 157 illustrates this configuration.
156 ■
Configuring PPPoE over a Static Ethernet Interface
JUNOSe 11.1.x Link Layer Configuration Guide