Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010, Configuration Manual

Page: 675 / 774

shutdown” on page 655 to remove dynamic ATM 1483 interfaces created within
a subrange.
■
Removal of a subrange automatically results in the removal of all overriding
profile assignments on that subrange.
■
You can create a bulk-configured VC subrange that includes the VPI and VCI
addresses belonging to an existing ATM PVC on a static ATM interface.
■
You cannot create a bulk-configured VC range on an ATM interface on which
you have configured CAC. Conversely, you cannot configure CAC on an ATM
interface on which you have created a bulk-configured VC range. For information
about configuring CAC, see “Setting Optional Parameters” on page 24 in
“Configuring ATM” on page 3.
■
Example 1—Configures a VC range named myBulkConfig with a single VC
subrange containing VPIs 0–2 and VCIs 101–1100; this command configures a
total of 3000 VCs
host1(config-if)# atm bulk-config myBulkConfig vc-range 0 2 101 1100
■
Example 2—Configures a VC range named myMultiBulkConfig with two VC
subranges containing VPIs 0–1 and VCIs 101–600 (first subrange) and VPIs 3–5
and VCIs 201–3200 (second subrange); this command configures a total of
10,000 VCs
host1(config-if)# atm bulk-config myMultiBulkConfig vc-range 0 1 101 600
vc-range 3 5 201 3200
■
Use the no version to remove the specified VC range from the ATM AAL5
interface, to remove the specified subranges from the specified VC range, or to
remove all subranges from the specified VC range. The
no version also removes
any overriding profile assignments for ATM PVCs within the deleted VC range
or VC subrange.
■
See atm bulk-config.
atm class-vc
■
Use to assign a previously configured VC class to a base profile for a dynamic
ATM 1483 subinterface.
■
Issuing this command applies the set of attributes in the specified VC class to all
bulk-configured VC ranges that are dynamically created from this base profile.
■
You must issue the exit command from Profile Configuration mode for the VC
class association to take effect.
■
Changes to a VC class specified in a base profile apply only to those PVCs that
are dynamically created
after the change is made. These changes do not apply
to dynamic PVCs that were created prior to the VC class modification.
■
Example
host1(config-profile)# atm class-vc gold-subscriber-class
host1(config-profile)# exit
Configuring ATM 1483 Dynamic Subinterfaces
■ 643
Chapter 18: Configuring Dynamic Interfaces Using Bulk Configuration