Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010, Configuration Manual

Page: 328 / 774

max-failure 5
passive-mode disabled
LCP protocol status
link-status network
LCP negotiated options local peer
max-receive-unit 1492 1492
authentication none chap
magic-number 0x3e51ca08 0x740bbf81
accm none none
pfc none none
acfc none none
LCP protocol statistics
in-keepalive-requests 11
out-keepalive-requests 11
in-keepalive-replies 11
out-keepalive-replies 11
keepalive-failures 0
max-renegotiation terminates 0
IP protocol statistics
max-renegotiation-terminates 0
IPv6 protocol statistics
max-renegotiation-terminates 0
Authentication configuration
authenticate-retry 0
authentication-router ''
aaa-profile ''
Authentication status
grant true
session-timeout none
inactivity-timeout none
monitor—ingress-only false
accounting-timeout none
peer-ip-address none
peer-ip-address-mask none
peer-primary-dns-address none
peer-secondary-dns-address none
peer-primary-wins-address none
peer-secondary-wins-address none
peer-ipv6–interface-id none
Authentication statistics
up-time 0 seconds
in-octets 0
out-octets 0
in-packets 0
out-packets 0
PAP protocol configuration
request-timeout 20 seconds
CHAP protocol configuration
name ''
challenge-retry 10
challenge-timeout 4 seconds
minimum-challenge-length 16
maximum-challenge-length 32
minimum-rechallenge-timeout 0 seconds
maximum-rechallenge-timeout 0 seconds
EAP Protocol Configuration
request-retry 5
request-timeout 3 seconds
■
Example 2—Provides detailed output for a particular IPv6 interface
296 ■
Monitoring PPP Interfaces
JUNOSe 11.1.x Link Layer Configuration Guide