Juniper JUNOSE 11.1.X - LINK LAYER CONFIGURATION 4-7-2010, Configuration Manual

Page: 284 / 774

Table 11: show ethernet oam lfm discovery Output Fields (continued)
Field Description Field Name
Functions that the interface of the local entity can perform, such
as link monitoring or responding to remote loopback requests.
With this information a peer can determine what functions are
supported and accessible; for example, loopback capability. All
the configured settings on the local interface for OAM tasks are
displayed in this field
Displays one or more of the following values:
■
unidirectional—Indicates the ability to operate a link in a
unidirectional mode for diagnostic purposes
■
loopback—Indicates whether remote loopback is supported
or unsupported
■
link events—Indicates whether interpreting link events is
supported or unsupported on the remote peer
■
variable retrieval—Indicates whether the local OAM entity
supports receipt of performance MIB variables from its peer
entity variable requests using Variable Request OAM PDUs
Capabilities
State of the multiplexer functions of the OAM sublayer for the
local OAM entity. Device is forwarding non-OAM PDUs to the
lower sublayer or discarding non-OAM PDUs Mux Action
State of the parser functions of the OAM sublayer for the local
OAM entity. Device is forwarding non-OAM PDUs to higher
sublayer, looping back non-OAM PDUs to the lower sublayer, or
discarding non-OAM PDUs Parser Action
MAC address of the interface of the remote peer Remote ( address )
Discovery mode of the interface of the remote peer:
■
active—The interface discovers and monitors the entity on
the other side of the link if that entity also supports IEEE
802.3ah OAM functionality.
■
passive—An OAM entity does not initiate the discovery
process. You cannot perform link-fault management if you
configure both the local client and the remote peer for
passive mode operation
Mode
252 ■
Monitoring OAM Link-Fault Management Discovery Settings for an Interface
JUNOSe 11.1.x Link Layer Configuration Guide