Ross Synergy 100, Руководство по установке, Страница: 98 / 246

6–10 • BNC Configuration and Check Synergy 100 Installation Guide (v16.10-S100)
Checking Inputs
At this point in the installation process, ensure that you have performed the following tasks for each
BNC input :
• Set up its BNC type
• Set up its auto key association (if the input has an alpha signal)
• Set up its alpha parameters (shaped or unshaped if the input is an alpha signal)
• Set up its control panel button mapping
• Set up its tally
Now, use the following procedure to check your inputs:
1. Ensure that the program monitor is connected to the PGM 1 output connector (on the
rear chassis).
2. Ensure that each source device connected to the switcher is putting out a signal. These
will include cameras, VTRs, DVEs, character generators, still stores, etc.
3. Using your “ Input Worksheet ” as a guide, press each control panel button on the PGM
bus, starting with crosspoint 1. Verify that each signal is present on the crosspoint (as
mapped) and that it matches each connected signal as written on your worksheet.
4. For each shifted crosspoint, press and hold the SHIFT button, then press the desired
button on the PGM bus.
5. If any signal does not match, check your “ Input Worksheet ” against the settings that
you made on the Panel Menu .
This completes the procedure to check your inputs.
Important
If all installation changes are now complete, return the Installation
Enable Jumper ( DIP Switch 4 , SW7 on the Frame CPU Board ) to
the Up position (toward the Rear of the board).