Ross Synergy 100, Руководство по установке, Страница: 70 / 246

3–4 • Preliminary Cabling and Check Synergy 100 Installation Guide (v16.10-S100)
2. Connect a 6-pin shielded Telco cable (of the supplied or custom length) between the
frame’s AUX PANEL connector and the connector labeled MAIN on the rear of the first
Aux panel in line.
3. To daisy-chain additional Aux panels (up to 8), connect a 6-pin shielded Telco cable
between the Aux panel connector labeled ECHO and the connector labeled MAIN on
the next Aux panel in line.
4. Repeat step 3 for all additional Aux panels in the daisy-chain (up to the maximum of 8
panels per chain).
Aux Panel Cabling Notes
Please note the following points regarding all remote Aux panels:
• All 10 Aux outputs on the frame are provided as standard. However, outputs 1 and 2 are
not yet implemented. Aux outputs 3 to 10 are untimed.
• The Aux panel connector on the electronics frame is universal — it can control any of
the remote Aux panels.
• Aux panel crosspoint labels are provided with each panel. Refer to the section
“
Pushbutton Inserts ” on page 4–5 for labeling instructions.
Reference Signal Connection
A digital reference signal must be connected to the switcher. Please note:
• Connect the digital reference signal to the connector marked 601 REF IN on the rear of
the frame.
• No menu configuration of the reference signal is required.
• Always use a stable reference signal, preferably black, that is low in jitter and that
originates from a reliable digital test signal generator.
• The switcher regenerates black from the assigned reference input.
Monitor Connection
Connect either the PGM 1 or PGM 2 BNC output on the rear of the frame to your serial digital
program monitor. Please note:
• If you are using a serial digital monitor, connection is direct.
• If you are using an analog monitor, one of three D-A converters is required:
~ Serial Digital to NTSC
~ Serial Digital to PAL
~ Serial Digital to Analog Component
For information on Ross Video’s full line of conversion equipment, contact your sales
representative or Ross Video Limited.
Note
If you elect to use analog black as your reference (based on your
facility’s requirements), you must use an external A-D converter. For
information on Ross Video’s full line of conversion equipment, contact
your sales representative or Ross Video Limited.