Ross Synergy 100, Руководство по установке, Страница: 130 / 246

7–30 • Communication Setup Synergy 100 Installation Guide (v16.10-S100)
~
RS422
— Use this option if the device uses the RS-422 communications
protocol.
• Press the right
SEL
button to accept the new settings.
8. If you are using the Contribution protocol, you must set up the extra options for your
serial tally interface device. Complete the procedure in the section “ Contribution Serial
Tally Extra Options ” on page 7–30 to finish setting up your serial tally interface
device. If you are not using the Contribution protocol, proceed to the next step.
9. If you are using the Look Ahead Serial Tally protocol, you must set up the extra
options for your serial interface device. Complete the procedure in the section “ Look
Ahead Serial Tally Extra Options ” on page 7–32 to finish setting up your serial tally
interface device. If you are not using the Look Ahead Serial Tally protocol, proceed to
the next step.
10. Press
MENU
to display the Installation Change Screen .
11. Accept or cancel these changes as follows:
• Press
0. Confirm
to accept the changes.
• Press
1. Cancel
to exit the menus safely, without making any changes. The system
returns to the previously stored settings.
This completes the procedure for setting up a serial tally interface device on a peripheral port.
Contribution Serial Tally Extra Options
The Contribution protocol has extra options that must be setup to properly communicate with a serial
tally interface device.
Use the following procedure to set up the Extra Options for your serial tally interface device:
1. Ensure that the Communication Menu is displayed and that menu item
0. Port
is set to
the serial tally interface device you want to set up the extra options for.
2. Assign a specific serial tally interface device to the selected peripheral port as follows:
• Press
8. Option
.
• Use the
UP ARROW
or
DOWN ARROW ( 1
or
10 )
buttons to select
Rate
.
• Press the right SEL button to accept the new settings.
• Press
9. Rate
.
• Use the UP ARROW or DOWN ARROW ( 1 or 10 ) buttons to select the length of
time (in fields) between update messages sent by Synergy to the serial tally
interface device.The default value of
26 is the recommended setting, but you can
choose any value between 2 and 60 , inclusive.
• Press the right
SEL
button to accept the new settings.
Important True RS-232 is only available on Peripheral Port 2 . However, you
can connect an audio board using RS-232 protocol to Peripheral Port
1 if the Protocol heading is set to RS-422 , and an RS-422-to-RS-232
converter is used.
Note When menu item 8. Option is set to Rate , menu item 9. Reserved
changes to 9. Rate .