Ross Synergy 100, Руководство по установке, Страница: 161 / 246

Synergy 100 Installation Guide (v16.10-S100) Additional Installation Setups • 8–27
Setting up Remote Aux Panel GPIs
The Dedicated and Assignable Remote Aux Panels include a special feature that allows a camera
operator to manually override the Aux panel selection using GPI trigger. For purposes of matching or
monitoring cameras, the camera operator can override the selected Aux Bus crosspoint and manually
switch to a camera’s crosspoint — simply by pushing a button on the joystick of the Camera Control
Unit (CCU).
Please note:
• Each Aux Panel provides 8 GPI input ports. These GPIs are completely separate from
and are available in addition to those already provided on the frame. The GPI capability
is not available on first-generation remote panels from Ross Video.
• A maximum of 64 GPIs can be distributed over eight different remote panels. The
practical maximum limit of 8 Aux panels should still be observed.
• Each panel has provisions for offsetting its GPI port numbers, such that panel #1 uses
ports 1 - 8, panel #2 uses ports 9 - 16, etc. The selection of Panel # ( 1) is
performed during programming mode of each Remote Aux Panel that will be used for
remote GPIs.
• Each remote GPI port is dedicated exclusively to the control of Aux Bus signal selection,
such as using a contact closure from a CCU. No other functions can be assigned to these
remote GPIs.
Four steps are required to properly set up Remote Aux Panel GPIs:
• Remote Aux Panel GPI Input Worksheet
• Remote Aux Panel GPI connection
• Remote Aux Panel GPI programming
• Setting up Remote GPIs for CCU Joystick Aux Control
Each step is explained in detail in the following sections.
Remote Aux Panel GPI Input Worksheet
Complete the following Remote Aux Panel GPI Input worksheet, or, to avoid marking up the
Installation Guide , use the worksheet provided in the section “ Standard Frame GPI Input
Worksheet ” on page 13-4 to make extra copies.
In the table, note that remote GPI numbers, group numbers, offset numbers and physical panel GPI
numbers have already been filled in. For each remote Aux Panel GPI port:
• In the
Assigned Aux Bus
column, select the Aux Bus (
3
-
10
) that you want to assign
to the GPI group (
1
-
8
).
• In the
Assigned BNC
column, select the switcher’s BNC crosspoint that you want to
select when the specific CCU’s joystick button is pressed.
• In the
Physical Connection
column, note the Camera CCU that must be connected to
the physical GPI line.