Ross Synergy 100, Руководство по установке, Страница: 140 / 246

8–6 • Additional Installation Setups Synergy 100 Installation Guide (v16.10-S100)
3. Press
MENU
to display the Installation Change Screen .
4. Accept or cancel these changes as follows:
• Press
0. Confirm
to accept the changes.
• Press
1. Cancel
to exit the menus safely, without making any changes. The system
returns to the previously stored settings.
This completes the procedure to adjust the reference delay of the Synergy 100 switcher.
Clean Feed Setup
The Clean Feed option in the Outputs Menu allows you to set the point from which the clean feed
signal is derived. The selected signal then appears on the Clean output connector on the rear of the
frame.
Use the following procedure to set the Clean Feed output:
1. Navigate to the Outputs Menu as follows:
• Press MENU to display the Main Menu on the Preview Overlay .
• Press 2. Outputs to display the Outputs Menu .
Outputs Menu
2. Set the Clean Feed of the switcher as follows:
• Press 2. Clean .
• Use the UP ARROW or DOWN ARROW ( 1 or 10 ) buttons to select the point
from which the clean feed signal is derived. You can choose between the following:
~
BeforeKeys — Use this option to have the clean feed pulled before keys are
added.
~ AfterKeys — Use this option to have the clean feed pulled after keys are
added, effectively giving you another PGM output.
~ AlphaKey1 — Use this option to have the clean feed output as the alpha
signal for Key 1.
~ BeforeDSK — Use this option to have the clean feed pulled downstream of
the two Effects keyers, but upstream of the DSK.
• Press the right SEL button to accept the new settings.
3. Press MENU to display the Installation Change Screen .
4. Accept or cancel these changes as follows:
Outputs
0. Aspect
1. Ref Dly 4:3
300
MENU
Exit 100
Previous SEL
Accept 10
Down
1
Up
2. Clean BeforeKeys
3. Ancillary data
4. RemAuxPrg Off
5. Fld Dom Field1