Ross Synergy 100, Руководство по установке, Страница: 149 / 246

Synergy 100 Installation Guide (v16.10-S100) Additional Installation Setups • 8–15
Personality Setup
The Personality Menu for the Synergy 100 provides users with the ability to enable transition
previews, select which output you want your Overlay displayed on, set the switcher’s timeout interval,
and
customize the DSK operation and MENU button behavior of their switcher.
The Personality Menu allows you to do the following:
• Enable full previews of your selected transitions.
• Define how the DSK behaves when sources are taken on the PGM Bus .
• Program a desired timeout interval, in minutes, before the switcher goes into “sleep”
mode.
• Dictate the behavior of the MENU button when you have the Editor option installed.
• Enable AutoRcall to automatically retrieve the state of the Effects Dissolve button when
a memory was saved.
• Enable GPI Outputs to be triggered using the E
FFECTS
C
ONTROL
buttons.
• Display fine tune values, in the S
YSTEM
C
ONTROL
area, when using knobs in the
MATTES or K
EYERS
areas.
Transition Preview
The Trans Preview mode allows you to preview a complete transition on the preview monitor
without affecting the program output.
Use the following procedure to enable the Transition Preview mode:
1. Navigate to the Personality Menu as follows:
• Press
MENU
to display the Main Menu .
• Press
6. Personality
to display the Personality Menu .
Personality Menu
2. Toggle the 0.Trans PV between On and Off as follows:
• On — Use this option to enable the “trans preview mode” and allow complete
transition preview.
• Off — Use this option to disable the “trans preview mode” and prohibit any kind of
transition preview.
Note
For information on enabling the Audio Cut mode, refer to the section
“ Audio Cut Mode Setup ” on page 7-26.
Personality - Synergy 100
0. Trans PV
1. DSK Drop On
Manual
MENU
Exit 100
Previous SEL
Accept 10
Down
1
Up
2. SleepTime 10 min
3. Menu Bttn
Menu Only
4. AutoRcall On
5. GPIO Mode Disabled
6. Show Knob 0
7. Audio Cut
On