Ross Synergy 100, Руководство по установке, Страница: 42 / 246

2–8 • Installation Synergy 100 Installation Guide (v16.10-S100)
6. Power On LED
The
POWER ON
LED should be lit green during normal operations. It indicates that
there are no error conditions in the fan or power supply. This LED is off if any of the two
“fail” LEDs are lit.
7. Power Switch
The
POWER
switch turns on the power supply.
8. Fuse
One
FUSE
is provided for the power supply. The fuse is rated at 250V, 4A.
Frame, Rear Connector Panel View
The following figure illustrates the rear connector panel of the Synergy 1 SD frame.
Synergy 1 SD Frame, Rear View
The following are descriptions of each rear panel connector.
1. Fan Exhaust Vent
A grill is provided for FAN EXHAUST , behind the power supply. To prevent the frame
from overheating, do not block the exhaust vent with cables or other equipment.
2. Power Connector
One AC POWER connector is provided for frame power.
3. Power Supply LEDs
Four POWER SUPPLY LEDs are provided to indicate the condition of the power
supply (-12, +5, +10 and +15V). Under normal operating conditions, each should be lit
green.
1) Fan Exhaust Vent
2) Power Connector
3) Power Supply LEDs
4) Synergy 100 Panel Connector
5) Aux Panel Connector 6) Ross 210/216 Panel Connector
7) GVG 100/110 Panel Connector
8) GPI I/O Connector
9) Tally Connectors
10) Editor Connector 11) DVE Connector
12) Peripheral 1 Connectors
13) Peripheral 2 Connectors
14) Output Section
15) Input Section
POWER
OK -12 +5 +10 +15
SYNERGY
PANEL
AUX
PANEL
210/216 PANEL
100/110 PANEL
GPI I/O TALLY
9 11 13 15
10 12 14 16 COMMON
1 3 5 7
2 4 6 8 COMMON
EDITOR DVE
PERIPHERAL 1 PERIPHERAL 2
Rx
Tx
Rx
Tx
IN
1 3 5 7
9
11 13 15
2 4 6 8 10 12 14 16
OUT
Aux 9
Aux 8
Aux 5
Aux 2 PV2
601 REF IN
Aux 10
Aux 7
Aux 4
Aux 1 PV1
PGM2 Aux 6
Aux 3
Clean
PGM1
MOUNT IN RACK ONLY
100-120 / 200-240V ~
50/60 Hz
2.7A 180W
1
3
2 6
7
8
9 10 11 12 13
4 5 14 15
2
1
This class A device complies with Canadian ICES-003 and part 15 of the FCC rules.
Operation is subject to the following conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
R