Ross Synergy 100, Руководство по установке, Страница: 128 / 246

7–28 • Communication Setup Synergy 100 Installation Guide (v16.10-S100)
Serial Tally Protocol Setup
Use the Serial Tally Protocol Setup procedures to set up communication parameters with tally
system interface equipment using industry standard protocol. Note that the standard parallel tally
interface will continue to operate normally when this option is enabled.
The following topics are discussed in this section:
• Serial Tally Setup
• Contribution Serial Tally Extra Options
• Look Ahead Serial Tally Extra Options
Serial Tally Setup
In order to connect a serial tally interface device to your Synergy 100 switcher, you must set up
communication with the serial tally device.
Use the following procedure to configure the Contribution Serial Tally protocol:
1. Navigate to the Communication Menu as follows:
• Press
MENU
to display the Main Menu on the Preview Overlay .
• Press
4. Communication
to display the Communication Menu .
Communication Menu — Serial Tally
2. Select the peripheral port that is connected to the serial tally interface device as follows:
• Press 0. Port .
• Use the UP ARROW or DOWN ARROW ( 1 or 10 ) buttons to select the
peripheral port that your serial tally interface equipment is connected to. You can
choose between the following:
~
Periph1 — Use this option if serial tally interface equipment is connected to
Peripheral port 1.
~ Periph2 — Use this option if serial tally interface equipment is connected to
Peripheral port 2.
Note The Serial Tally Interface option must be installed in order to set up
serial tally communications. Refer to the section “ Installing Software
Options ” on page 2–30 for instructions on verifying the status of
installed options.
Communication
0. Port
1. Type Periph2
Ser.Tally
MENU
Exit
100
Previous 10
Down
1
Up
SEL
Accept
2. Device
3. Baud
4. Parity Contrib
38400
Odd
5. Protocol
6. Input
RS232
None
7. Monitor
8. Option
9. Rate
Rate
24