Ross Synergy 100, Руководство по установке, Страница: 177 / 246

Synergy 100 Installation Guide (v16.10-S100) Completing Setup • 9–7
3. Insert a storage device as follows:
• Insert a pre-formatted 1.4 MB high-density floppy disk into the floppy disk drive of
the Synergy 100 switcher.
OR
• Insert a USB key into the USB port of the Synergy 100 switcher. You must wait 5
seconds after inserting the USB key into the USB port before you can save or recall
registers to it.
4. If you wish to store all categories of registers to disk, press
0. All
. This action writes
four or five files to your storage device in succession, depending on whether or not you
have the
Squeeze & Tease WARP option installed:
• Memory Registers are stored in the file MEMORYS.SYN .
• S&T3D Memories (if the Squeeze & Tease WARP option is installed) are stored
in the file ST3DMEM.SYN
.
• Personality Registers are stored in the file PERS.SYN .
• Installation Registers are stored in the file INSTALL.SYN .
• 3D Wipes Registers are stored in the file ST3DSEQ.SYN
5. If you wish to save only the two files that pertain to your installation setups, proceed as
follows:
• Press 2. Personality to save Personality Registers to a storage device. The file
PERS.SYN is saved.
• Press 3. Installation to save Installation Registers to a storage device. The file
INSTALL.SYN is saved.
Important Pressing 6. Store All Pre V12 stores all of the above registers to your
storage device in a format that is compatible with switcher software
versions earlier than version 12. Therefore, if you are downgrading
your switcher software from version 12 to an earlier version, use this
method to store all your switcher configurations to a storage device.
Note that a floppy disk created in this manner can still be loaded onto a
pre-version 16 switcher, but it will load significantly slower than a disk
that was saved using the
0. All
option.
Note
If you wish, you can store only the memories , or only the 3D wipes to
disk in the same manner as outlined for the two categories listed above.
To store
only individual 3D wipes , proceed to step 6.
If you store a category that already contains a file on the storage
device, the category will be overwritten.