Ross Synergy 100, Руководство по установке, Страница: 212 / 246

11–4 • Appendix B. Hardware Options Synergy 100 Installation Guide (v16.10-S100)
Squeeze & Tease 2D Installation
This section provides instructions for installing the Squeeze & Tease 2D option on the Synergy 1
Frame Board.
Use the following procedure to install the Squeeze & Tease 2D option:
1. Power down the Synergy 1 frame.
2. Carefully remove the Synergy 1 Frame Board from the chassis, and set it on a clean,
flat, static free surface, with the rear of the board away from you.
3. Unpack the Squeeze & Tease 2D kit, consisting of one Squeeze & Tease 2D Module
(4000A-048).
Squeeze & Tease Mounting Location
4. Locate the 3 sockets labeled “ Squeeze & Tease Conn ” on the Synergy 1 Frame Board ,
near the middle, front of the board. Refer to the figure above.
• Carefully align the module over the sockets.
• Ensure that the components of the S&T Module board are facing up.
• Use your fingers to “feel” for the proper pin-to-socket alignment.
• While applying downward pressure, slowly rock the module until the module is
fully seated. Avoid flexing the board — so as not to bend the pins.
• After installation, “sight” down the board at the connector level, to make sure that
there are no exposed pins. It is recommended that you rotate the board 360 degrees
to check all planes.
Note If you have the Squeeze & Tease WARP option installed, refer to the
Synergy 100 Squeeze & Tease 3D / WARP Owner’s Guide for
complete installation and operation instructions.
Caution
Observe all static discharge precautions throughout the procedure.
Squeeze & Tease
Mounting Location