Ross Synergy 100, Руководство по установке, Страница: 226 / 246

12–10 • Appendix C. Diagnostics Synergy 100 Installation Guide (v16.10-S100)
9. To exit Calibration Mode :
• Press any button on the lower portion of the panel. In the four-character displays
across the top of the panel, you will receive a message asking you if you want to
save the calibration:
~
To return the switcher to normal operating mode without accepting the newly
calibrated controls, press
SEL
in the System Control Group .
~ To complete the calibration and return the switcher to normal operating mode,
press
SEL
in the Mattes Group .
10. On rare occasions, if you choose to save the calibration, the new settings fail to save
correctly. If this occurs, a message will appear in the display area informing you of this.
In addition, the
SEL
buttons in the Mattes and System Control groups will light. Press
either of these buttons to confirm receiving the warning.
You can then attempt to save the settings a second time simply by re-entering calibration
mode (as per Step 1), and then exiting it. You will again be asked if you wish to save the
calibration, to which you can select
Yes
in the Mattes Group .
This completes the procedure to calibrate the analog controls of the Synergy 100 switcher.