Ross Synergy 100, Руководство по установке, Страница: 151 / 246

Synergy 100 Installation Guide (v16.10-S100) Additional Installation Setups • 8–17
Sleep Time
The SleepTime setting allows you to specify the number of minutes that pass before the switcher goes
into “sleep” mode. “Sleep” mode occurs when no control panel buttons or knobs are touched and the
fader arm is not moved for a set amount of time.
Use the following procedure to set up the Sleep Time for your Synergy100 switcher:
1. Navigate to the Personality Menu as follows:
• Press
MENU
to display the Main Menu .
• Press
6. Personality
to display the Personality Menu .
Personality Menu
2. Set the length of time (in minutes) for the Synergy 100 to fall asleep as follows:
• Press
2. Sleep Time
.
• Use the UP ARROW or DOWN ARROW ( 1 or 10 ) buttons to scroll to the
desired time interval between 1 minute and 240 minutes.
~
If you wish to turn the “sleep” mode off, scroll down past 1 minute to
Off
and
press
SEL
.
• Press the right
SEL
button to accept the new settings.
3. Press MENU to display the Installation Change Screen .
4. Accept or cancel these changes as follows:
• Press 0. Confirm to accept the changes.
• Press 1. Cancel to exit the menus safely, without making any changes. The system
returns to the previously stored settings.
This completes the procedure to set up the Sleep Time interval.
Operating
Tip
The time will change color to indicate that it is active and can be
changed.
Personality - Synergy 100
0. Trans PV
1. DSK Drop On
Manual
MENU
Exit 100
Previous SEL
Accept 10
Down
1
Up
2. SleepTime 10 min
3. Menu Bttn Menu Only
4. AutoRcall On
5. GPIO Mode Disabled
6. Show Knob 0
7. Audio Cut
On