Ross Synergy 100, Руководство по установке, Страница: 126 / 246

7–26 • Communication Setup Synergy 100 Installation Guide (v16.10-S100)
5. Press
MENU
to display the Installation Change Screen .
6. Accept or cancel these changes as follows:
• Press
0. Confirm
to accept the changes.
• Press
1. Cancel
to exit the menus safely, without making any changes. The system
returns to the previously stored settings.
This completes the procedure to set a level for an audio channel.
Audio Cut Mode Setup
The Audio Cut mode enables you to specify that all audio transitions perform a “cut” between your
sources regardless of whether you press the
AUTO TRANS
button, the
CUT
button, or use the Fader
for the transition. Note that this is not a true “cut” transition — the speed that one channel is taken off
air and the next channel is taken on air depends on the Audio Mixer.
If you disable the Audio Cut mode by selecting the
Off
option, the audio transition will reflect the
type of transition selected. For example, if you press the
AUTO TRANS
button, the audio transition
will be performed at the same rate as the video transition. If the Fader handle is used to perform a
manual transition, the audio transition will progress at the same rate as the
Transition Progress Bar .
Refer to Chapter 5, “ Transitions ” in the Synergy 100 Operation Guide , for more information on
performing transitions.
Use the following procedure to setup the Audio Cut mode:
1. Navigate to the Personality Menu as follows:
• Press
MENU
to display the Main Menu .
• Press
6. Personality
to display the Personality Menu .
Personality Menu
2. Setup the Audio Cut mode as follows:
• Press 7. Audio Cut .
• Use the UP ARROW or DOWN ARROW ( 1 or 10 ) buttons to select between On
and Off as follows:
~
On
— Use this option to enable the Synergy 100 Switcher to perform a “cut”
between the PST and PGM audio sources. This is the default setting.
~
Off
— Use this option to set the audio transition rate to the video transition
rate.
• Press the right
SEL
button to accept the new setting.
Personality - Synergy 100
0. Trans PV
1. DSK Drop On
Manual
MENU
Exit 100
Previous SEL
Accept 10
Down
1
Up
2. SleepTime 10 min
3. Menu Bttn Menu Only
4. AutoRcall On
5. GPIO Mode Disabled
6. Show Knob 0
7. Audio Cut
On