Ross Synergy 100, Руководство по установке, Страница: 61 / 246

Synergy 100 Installation Guide (v16.10-S100) Installation • 2–27
9. Power on the frame.
This completes the procedure for upgrading system software. Please continue with the “ Restoring
Registers ” procedure.
Notes on Upgrading Software with a USB Key
Please note:
• Synergy 100 systems released before version 16 are able to load version 16 or later
software, and revert back to earlier versions.
• If you have received a Synergy 100 system with version 16 software already loaded on
it, you will
not be able to load pre-version 16 software onto it regardless of whether you
have a USB port or floppy disk drive.
• The following messages may be displayed on the Synergy 100 control panel during the
software upgrade process:
~
WAIT USB
— This message informs you that the Synergy 100 control panel is
trying to communicate with the USB port and read the USB key. Once the control
panel detects the USB key, the message is no longer displayed.
~
USB UPGD
— This message informs you that the Synergy 100 switcher is in the
process of a software upgrade and will be displayed until the process is complete.
~
USB UPGD FAIL
— This message informs you that the Synergy 100 control panel
has failed to upgrade. Contact Ross Video Technical Support for more information.
Restoring Registers
Use the following procedure to restore your registers to on-line memory:
1. Ensure that new Synergy software version is properly installed. If not, refer to the
section “ Software Upgrade ” on page 2-25.
2. Locate the “backup” storage device that you made in the section “ System Backup ” on
page 2-24.
3. Read the entire contents of the storage device into switcher memory as follows:
• Navigate to the Recall Menu as follows:
~ Press MENU to display the Main Menu .
~ Press 5. Disk to display the Disk Menu .
~ Press button 0. Recall to display the Recall Menu .
• Insert the backup storage device into the Synergy 100 switcher.
• Press 0. Recall All .
• Press SEL .
4. Eject the storage device from the switcher.
This completes the procedure for restoring your registers.
Caution
Do NOT remove the floppy disk or USB key from the switcher before
the LED on the floppy drive or USB port goes out. Doing so may
destroy the data on your floppy disk or USB key, as well as the data on
the next one you insert into the switcher