Ross Synergy 100, Руководство по установке, Страница: 215 / 246

Synergy 100 Installation Guide (v16.10-S100) Appendix B. Hardware Options • 11–7
Ultimatte Insider Installation
Ultimatte Insider ™ is a hardware option that adds true Ultimatte capability — directly inside the
Synergy 100 switcher. The option comprises a hardware board designed by Ultimatte, the
Oscar-winning industry leader in compositing technology.
Please note the following important points:
• The Ultimatte Insider board is allocated to only one of the MLE’s two keyers. The
Ultimatte will automatically be associated with the first keyer in which a Chroma Key
key type is selected.
• The Ultimatte Insider board creates two signals from a selected video source — a
processed fill and a processed alpha signal.
• Even though the Ultimatte Insider board is allocated to only one of the keyers, any of
the 16 inputs can be used as an Ultimatte key source.
Ultimatte Insider Board Installation
This section provides instructions for installing an Ultimatte Insider board on the Frame CPU Board.
Use the following procedure to install the Ultimatte Insider option:
1. Power down the Synergy 1 chassis.
2. Carefully remove the Synergy 1 Frame Board from the chassis, and set it on a clean,
flat, static free surface, with the rear of the board away from you.
3. Unpack the Ultimatte Insider kit, consisting of one Ultimatte Module .
4. Locate the 2 sockets labeled “ Option Conn ” on the Synergy 1 Frame Board , near the
right, front of the board.
• Carefully align the module over the sockets.
• Ensure that the Ultimatte Module board’s components are facing up.
• Use your fingers to “feel” for the proper pin-to-socket alignment.
• While applying downward pressure, slowly rock the module until the module is
fully seated. Avoid flexing the board — so as not to bend the pins.
• After installation, “sight” down the board at the connector level, to make sure that
there are no exposed pins. It is recommended that you rotate the board 360 degrees
to check all planes.
5. When complete, carefully replace the Synergy 1 Frame Board into the chassis, and
secure with the outer latches on the board edges.
This completes the installation for the Ultimatte Insider option. Refer to the Synergy 100 Operation
Guide for operating instructions.
Caution
Observe all static discharge precautions throughout the procedure.
Caution
Failure to reinstall a module with a precise 1:1 pin-to-socket
orientation will damage the Synergy 1 Frame Board, the selected
module — or both! Double check your work!