Ross Synergy 100, Руководство по установке, Страница: 158 / 246

8–24 • Additional Installation Setups Synergy 100 Installation Guide (v16.10-S100)
3. Select the GPI you wish to configure as follows:
• Press
0. Input
.
• Use the
UP ARROW
or
DOWN ARROW
(
1
or
10
) buttons to select the actual
GPI number that you wish to configure. You can choose between
1
and
12
.
• Press the right
SEL
button to accept the new settings.
4. Assign a panel button to the GPI input as follows:
• Press
1. Function
.
• Use the
UP ARROW
or
DOWN ARROW
(
1
or
10
) buttons to select a button to
trigger when a GPI input pulse is received from an external device. You can choose
between the following:
~
Cut
— Use this option when you want the transition to happen as a cut.
~
AutoTrans
— Use this option when you want the transition to happen at a
predetermined rate.
GPI Trigger Functions — Transition Control Group
~ MemRecall — Use this option when you want to recall one of your
previously-stored memories.
~ None — Use this option to perform no function when an incoming pulse is
received from an external source.
• Press the right SEL button to accept the new settings.
Note When menu item 1. Function is set to MemRecall , menu item 2.
Area changes to 2. Memory .
T
RANSITION
C
ONTROL
BKGD KEY1 KEY2 SHIFT
SHIFT
SHIFT
DISS WIPE DVE
CUT
AUTO
TRANS
HOLD FOR TRANSITION PREVIEW
TRANS
LIMIT
PST
BLACK
FADE
TO
BLACK
ON AIR ON AIR
ON AIR
DSK
CUT DSK
DISS
Cut
Auto Trans
Fade to Black
Fade to Black
DSK Cut
DSK Dissolve