Ross Synergy 100, Руководство по установке, Страница: 44 / 246

2–10 • Installation Synergy 100 Installation Guide (v16.10-S100)
• Two BNCs labeled
Rx
and
Tx
are provided for future peripheral control
requirements such as control panel networking.
13. Peripheral 2 Connectors
The
PERIPHERAL 2
group includes three connectors:
• One 9-pin “D” RS-422/RS-232 connector is provided for connection to a primary
peripheral device. The connection is for control purposes. The port can be
configured for additional serial control purposes through the menu system.
• Two BNCs labeled
Rx
and
Tx
are provided for future peripheral control
requirements such as control panel networking.
14. Output Section
Fifteen BNCs are provided as the switcher outputs, plus the digital 601 reference input,
as follows:
• Two program outputs (
PGM1
and
PGM2
).
• Two preview outputs (
PV1
and
PV2
). Both outputs, Aux outputs 1 and 2 display
the overlay as controlled from the menu system.
• Eight Aux bus outputs (
Aux3
through
Aux10
). Aux outputs 3 through 10 are
always untimed.
• One optional clean feed output (
CLEAN
).
• One digital reference input (
601 REF IN
).
If DAs are required to provide additional outputs for a particular signal, contact Ross
Video or your Ross Video dealer for details.
15. Input Section
Sixteen BNCs are provided for the digital inputs of the switcher.
Installation at a Glance
The following section presents a brief overview of the installation process. The exact steps taken in
installing your switcher will depend on the specific options that you have purchased.
Experienced installers may wish to work from this outline as required.
• Install the control panel.
• Install any remote Aux panels.
• Install the electronics frame in an equipment rack.
Note The two Peripheral 1 BNCs share the same internal circuitry as the
9-pin “D” Peripheral 1 connector. Only one of the two sets of
connectors can be used at a time.
Note The two Peripheral 2 BNCs share the same internal circuitry as the
9-pin “D” Peripheral 2 connector. Only one of the two sets of
connectors can be used at a time.
Note
All cautionary rules regarding static discharge apply. Refer to the
section “
Static Discharge ” on page 2-2 for details.