Ross Synergy 100, Руководство по установке, Страница: 120 / 246

7–20 • Communication Setup Synergy 100 Installation Guide (v16.10-S100)
In order to allow the Synergy 100 Switcher to communicate with the Audio Mixer, you must
configure it as described in this section.
Use the following procedure to setup your Yamaha DM1000 Audio Mixer:
1. Press the
SETUP
function button in the Display Access Group to display the SETUP
Menu .
2. Press the
MIDI/HOST
tab to display the MIDI/HOST SETUP Menu .
3. Use the
Cursor
buttons to navigate to the following (you will have to press
ENTER
after each selection):
• TO SERIAL HOST — Use the Parameter Dial to set this to
PC-2
.
• Rx PORT — Use the Parameter Dial to set this to
SERIAL
.
• Tx PORT — Use the Parameter Dial to set this to
SERIAL
.
4. Press the
MIDI
function button in the Display Access Group to display the MIDI
Menu .
5. Press the
SETUP
tab to display the MIDI SETUP Menu .
6. Use the
Cursor
buttons to navigate to the RECEIVE Section and select the following,
all other parameters should be deselected (you will have to press
ENTER
after each
selection):
• Fader Resolution — Use the Parameter Dial to set this to LOW .
This completes the procedure for setting up the Yamaha DM1000 Remote Audio Board to
communicate with the Synergy 100 switcher.
Note For information on the Function Buttons and navigating the menu
system on your Remote Audio Mixer, refer to the documentation that
came with your Audio Mixer.
Yamaha DM1000 Setup
Tx Rx OMNI ECHO
Channel 1 1 -- --
Program Change ON ON OFF OFF
Control Change ON ON -- OFF
Param Change ON ON -- OFF
Bulk -- OFF -- --
Other Commands -- -- -- --