Ross Synergy 100, Руководство по установке, Страница: 180 / 246

9–10 • Completing Setup Synergy 100 Installation Guide (v16.10-S100)
Recalling Configurations
As required, you can recall all categories of configuration registers from a storage device, or you can
simply recall the desired individual category. Typically, you will use this procedure in the following
situations:
• To recall a previous switcher setup if a problem occurs
• To recall a different setup for a new production requirement
• To restore a previous (or default) setup after making custom or temporary setup changes
Use the following procedure to recall your setup configurations from a storage device:
1. Ensure that any custom setups are saved to a storage device. If you have made any
changes to the switcher setup (in any of the file areas) and you have not backed them up,
they will be overwritten when you recall files.
1. Navigate to the Disk Menu as follows:
• Press MENU to display the Main Menu .
• Press 5. Disk to display the Disk Menu .
Disk Menu
2. Insert a storage device as follows:
• Insert the floppy disk with the desired setups into the floppy disk drive of the
Synergy 100 switcher.
OR
• Insert the USB key with the desired setups into the USB port of the Synergy 100
switcher. You must wait 5 seconds after inserting the USB key into the USB port
before you can recall registers from it.
Note
You must have the USB Removal Media Drive option installed in
order to save and recall configurations from a USB key.
Note
Remember that the file areas are independent. For example, if you only
recall Memory Registers , all Memory Registers , including S&T 3D
memories, if present, will be overwritten by the incoming data from
the floppy disk or USB key, but the other categories of registers will
not.
Disk
0. Recall
1. Store
MENU
Exit
100
Previous
10
Down
1
Up
SEL
Accept