Ross Synergy 100, Руководство по установке, Страница: 58 / 246

2–24 • Installation Synergy 100 Installation Guide (v16.10-S100)
Software Upgrade
This section provides step-by-step instructions for upgrading your Synergy 100 system software
from a storage device, such as a floppy disk or a USB key. You can obtain copies of all previous
software upgrade instructions by logging on to our web site at
http://www.rossvideo.com .
The following topics are discussed:
• System Backup
• Software Upgrade
• Restoring Registers
System Backup
Use the following procedure to save your setup configurations to a storage device:
1. Navigate to the Disk Menu as follows:
• Press
MENU
(to display the Main Menu ).
• Press
5. Disk
in the Effects Control group (to display the Disk Menu ).
2. Press button
1. Store
in the Effects Control group to display the Store Menu .
3. Insert a storage device as follows:
• Insert a pre-formatted 1.44 MB high-density floppy disk into the floppy disk drive
of the Synergy 100 Switcher.
OR
• Insert a USB key into the USB port of the Synergy 100 Switcher. You must wait 5
seconds after inserting the USB key into the USB port before you can save setup
configurations to it.
4. Press
0. Store All
in the Effects Control group.
Important Because the software upgrade process automatically returns the
switcher to default values, it is important that you back up all switcher
elements to a storage device, such as a floppy disk or USB key, at this
point.
Note If the floppy disk is not formatted (or if you wish to completely erase
all data from the disk), press
Format . Follow the instructions on the
display to format the floppy disk.
Note You must have the USB Removable Media Drive option installed in
order to use a USB key for saving and recalling setup configurations.
Caution Do NOT remove the floppy disk or USB key from the switcher before
the LED on the floppy drive or USB port goes out. Doing so may
destroy the data on your floppy disk or USB key, as well as the data on
the next one you insert into the switcher