Ross Synergy 100, Руководство по установке, Страница: 64 / 246

2–30 • Installation Synergy 100 Installation Guide (v16.10-S100)
3. Verify the version number of the processor boards as follows:
• The
5. Panel ID
heading displays the version number of the Synergy 100 panel’s
processor board.
• The
6. Frame ID
heading displays the version number of the Synergy 1 frame’s
processor board.
This completes the procedure to verify options.
Installing Software Options
There are three software options that are currently available with the Synergy 100 panel – Editor
control, Audio Mixer control, and Serial Tally interface. On the
Software Options Menu , the
headings for these options will indicate if the option is installed, with either an On or an Off displayed
in grey.
Use the following procedure to install a software option:
1. Navigate to the Software Options Menu as follows:
• Press MENU (to display the Main Menu ).
• Press 7. Options (to display the Options Menu ).
• Press 0. Software Options (to display the Software Options Menu ).
Software Options Menu
2. Call Ross Video Technical Support . Refer to the section “ A Word about Technical
Support ” on page 1-16 for contact information.
3. When you speak to the Technical Support representative, tell them your name, your
facility name, your serial number, which is displayed at the top of the menu, and the
Encrypt Code , which is displayed beside the Add heading. Technical Support keeps an
up-to-date record of each switcher’s configuration and option status.
Note
The DVE option is not yet implemented.
Note
The Encrypt Code is a random number that is generated each time the
switcher is powered up. Its purpose is to prevent unauthorized
installation of software options. The code remains valid until the
switcher is powered down or reset. The next time the switcher is
powered up, a
new Encrypt Code is generated.
Software Options - S/N:F422342234
MENU
Exit 100
Previous 10
Down 1
Up SEL
Accept
0. Add
1. Editor A6F8
On
2. DVE Off
3. Audio On
4. Ser.Tally On