Ross Synergy 100, Руководство по установке, Страница: 211 / 246

Synergy 100 Installation Guide (v16.10-S100) Appendix B. Hardware Options • 11–3
Clean Feed Installation
The Clean Feed option provides a second “program” output that is derived from a different location
than the standard program output. This output can be generated before or after all keys, including the
DSK, or after the Effects Keyers but before the DSK. The point from which the feed is derived is
software-configurable. The output itself is labeled
CLEAN on the rear chassis panel.
Use the following procedure to install the Clean Feed option:
1. Power down the Synergy 1 frame.
2. Carefully remove the Synergy 1 Frame Board from the chassis, and set it on a clean,
flat, static free surface, with the rear of the board away from you.
3. Unpack the Clean Feed kit, which consists of one Serializer Module (4000A-062).
4. Locate the socket labeled “ Clean Feed Out ” on the Synergy 1 Frame Board , near the
right, rear of the board.
• Carefully align the module over the socket.
• Ensure that the Serializer Module board’s components are facing to the rear.
• Use your fingers to “feel” for the proper pin-to-socket alignment.
• While applying downward pressure, slowly rock the module vertically (top to
bottom), until the module is fully seated. Avoid flexing the board — so as not to
bend the pins.
• After installation, “sight” down the board at the connector level, to make sure that
there are no exposed pins. It is recommended that you rotate the board 360 degrees
to check all planes.
5. When complete, carefully replace the Synergy 1 Frame Board into the chassis, and
secure with the outer latches on the board edges.
6. Using the menu system, set the point from which the clean feed signal is derived. Refer
to the section “ Clean Feed Setup ” on page 8-6 for instructions.
Once complete, the selected signal appears on the CLEAN output connector on the rear
of the chassis.
This completes the procedure to install the Clean Feed option.
Caution
Observe all static discharge precautions throughout the procedure.
Caution
Failure to reinstall a module with a precise 1:1 pin-to-socket
orientation will damage the Synergy 1 Frame Board, the selected
module — or both! Double check your work!