Ross Synergy 100, Руководство по установке, Страница: 146 / 246

8–12 • Additional Installation Setups Synergy 100 Installation Guide (v16.10-S100)
Remote Aux Panel GPI Programming
In this section, you will program your Remote Aux Panels for the desired group and offset . Refer to
your Remote Aux Panel GPI Input Worksheet to verify the groups and offsets for all buses.
Use the following procedure to program your Remote Aux Panel GPIs:
1. As required, refer to your Output Worksheet (located in the the section “ Output
Connection ” on page 4-8) to verify the destinations and functions of all Aux Bus
outputs.
2. Navigate to the Outputs Menu as follows:
• Press
MENU
to display the Main Menu on the Preview Overlay .
• Press
2. Outputs
to display the Outputs Menu .
Outputs Menu
3. Toggle the
4. RemAuxPrg
to On to enable Remote Aux Panel programming.
• When
RemAuxPrg
is set to On , the following actions occur:
~ All remote panels (both assignable and dedicated) are placed in “programming”
mode.
~ On all panels, the on-air LED flashes to alert you that programming mode is
now in effect.
4. Go to the first assignable or dedicated Aux panel that you want to program.
5. Ensure that the panel is in “programming” mode (with the on-air LED flashing).
6. Press CLEAN FEED to switch the panel from “assignment” programming mode to
“GPI” programming mode. The CLEAN FEED button flashes to indicate that GPI
programming mode is active.
With the GPI programming mode in effect, the first eight crosspoints on each panel
allow you to set the selected panel’s group and offset, as indicated below.
Note
This procedure allows you only to program the current panel . You can
not select other panels to program (from the panel you are currently
using) as you could in the previous “assignment” programming mode.
Outputs
0. Aspect
1. Ref Dly 4:3
300
MENU
Exit 100
Previous SEL
Accept
10
Down
1
Up
2. Clean BeforeKeys
3. Ancillary data
4. RemAuxPrg Off
5. Fld Dom Field1