Ross Synergy 100, Руководство по установке, Страница: 115 / 246

Synergy 100 Installation Guide (v16.10-S100) Communication Setup • 7–15
10. Accept or cancel these changes as follows:
• Press
0. Confirm
to accept the changes.
• Press
1. Cancel
to exit the menus safely, without making any changes. The system
returns to the previously stored settings.
This completes the procedure for setting up communications with a Remote Audio Mixer. Next you
must set up the Remote Audio Mixer to properly communicate with the Synergy 100 switcher.
Audio Mixer Interface Specifics
In order to complete the communications setup, you must configure the Remote Audio Mixer to
accept commands and communicate with the switcher. This section covers setting up the following
audio mixers:
• Yamaha 01V
• Yamaha 01V96
• Yamaha DM1000
Yamaha 01V
Please note the following important information regarding the Yamaha 01V audio mixer:
• The Synergy 100 connects to the Yamaha 01V via the Synergy 1 frame’s Peripheral
ports (1 or 2) and the Yamaha 01V’s TO HOST port.
• Baud rate: 38400, Parity: none, Data bits: 8, Stop bit: 1.
• The Yamaha 01V is controlled using a null modem cable with the following
connectors:
~
9-pin, D-type, Male RS-232 OR RS-422 at one end
~ 8-pin Mini DIN-to-PC male connector at the other end
• The following pin-outs are required for the NULL modem cable:
Note
For information on the function buttons and navigating the menu
system on your audio mixer, refer to your Audio Mixer documentation.
RS-232 Synergy-to-Yamaha 01V Wiring Chart
Synergy 1 Frame Yamaha 01V Panel
Peripheral 1-2
Connector Male
Signal TO HOST Port
Connector Male
Signal
1 n/c n/c
2 Tx → 2 Rx
3 Rx
→
3 Tx
4 n/c n/c
5 Ground
→
5 Ground
6 n/c n/c
7 n/c n/c
8 n/c n/c
9 n/c