Ross Synergy 100, Руководство по установке, Страница: 76 / 246

4–2 • Preliminary Video Installation Synergy 100 Installation Guide (v16.10-S100)
Input Worksheet
Complete the following worksheet for all of your video inputs, including primary sources, keys, and
fills. Following are basic input recommendations:
• Connect your digital reference video source to the 601 REF IN connector (as outlined in
the section “ Cabling ” on page 3–2). This automatically provides you with Black
(pushbutton 1 ) and your Color Background source.
• Connect your primary video sources to inputs 1 , 2 , 3 (etc.) and then continue forward in
sequence.
On the control panel, by default, input 1 is mapped to pushbutton 2 , input 2 is mapped to
pushbutton 3 , etc. This association will minimize subsequent re-mapping of your inputs
and make it very easy for you to locate inputs on the panel during the initial cabling
procedure.
• Connect your key signals (alphas) to your highest available input number and then
continue backwards in sequence. For example, start alphas at input 16 , then 15 , 14 , etc.
Using the above recommendations, complete the following input worksheet. The majority of this data
will be used in the section “
Setting Up BNC Inputs ” on page 6–3 to complete the configuration of
each input.
For each input (moving from left to right in the worksheet columns):
• Fill in the type of input. Choose between:
~ Off
~ Alpha
~ Other
• If the input is a key fill, choose the alpha with which you want the key fill to be
associated. List the primary source’s BNC number.
• If the input is an alpha, choose between Shaped ( Yes ) or unshaped ( No ) keying mode.
• Fill in the audio channel or group associated with the input’s two audio channels, if
applicable.
• Fill in the desired panel button on which you want to place the input signal (including
“shifted” buttons).
• Fill in the input’s tally number.
• To avoid marking up the Installation Guide , use the blank worksheet provided in the
section “ Input Worksheet ” on page 13–2 to make extra copies.
Note
If you elect to use analog black as your reference (based on your
facility’s requirements), you must use an external A-D converter. For
information on Ross Video’s full line of conversion equipment, contact
your sales representative or Ross Video Limited.