Ross Synergy 100, Руководство по установке, Страница: 79 / 246

Synergy 100 Installation Guide (v16.10-S100) Preliminary Video Installation • 4–5
Pushbutton Inserts
Once your inputs and alpha signal are connected, install the pushbutton designation inserts to identify
the sources for your inputs. All pushbutton inserts are printed on full-sized sheets of transparent
plastic and are easily installed under the lens caps — for both control panel and Aux panel
pushbuttons.
Standard films with common input designations are provided to all customers. If a designation that
you require has
not been included on a certain film and it is a type likely to be needed by other
switcher users, Ross Video would be pleased to consider adding it to the standard film.
Control Panel Pushbutton Inserts
Use the following procedure to install all control panel pushbutton inserts. Use the diagram below for
reference.
Control Panel Pushbutton Insert
1. Cut out the designation film inserts for the primary input pushbuttons.
2. Remove the lens assembly from the primary input switch by pulling straight upward on
the lens cap.
3. Remove the lens cap from the key cap and place the desired input designation under the
lens cap.
This completes the procedure to install all control panel pushbutton inserts.
Operating
Tip
A Lens Cap Remover is supplied in the Installation Kit .
Note
Ross Video will make custom inserts for your facility at a very
reasonable price. Please call us for details.
Operating
Tip
For best results when cutting out the button inserts, use a sharp
X-ACTO
®
knife and a steel-edged ruler.
Switch in Panel
Designation Film
Lens Cap
Key Cap