Ross Synergy 100, Руководство по установке, Страница: 154 / 246

8–20 • Additional Installation Setups Synergy 100 Installation Guide (v16.10-S100)
Show Knob Values Mode Setup
When the Show Knob Values mode is enabled, the S
YSTEM
C
ONTROL
area will display the fine
tuning values of the Mattes or Keyers knobs as a percentage. For example, if you rotate the Aspect
knob to the right. You can set the length of time the values are displayed.
Use the following procedure to enable the Show Knob Values mode:
1. Navigate to the Personality Menu as follows:
• Press
MENU
to display the Main Menu .
• Press
6. Personality
to display the Personality Menu .
Personality Menu
2. Enable the Show Knob mode and set the display time duration as follows:
• Press
6. Show Knob
.
• Use the UP ARROW or DOWN ARROW ( 1 or 10 ) buttons to select a display
time for the knob fine tuning values. You can choose between the following:
~
0 — Use this option to not display any knob fine tuning knobs. This is the
default setting.
~ 1- 5 — Use this option to set the number of seconds that the values will be
displayed in the S
YSTEM
C
ONTROL
area before returning to the previous
display.
• Press the right SEL button to accept the new settings.
3. Press
MENU
to display the Installation Change Screen .
4. Accept or cancel these changes as follows:
• Press
0. Confirm
to accept the changes.
• Press 1. Cancel to exit the menus safely, without making any changes. The system
returns to the previously stored settings.
This completes the procedure to enable the Show Knob Values mode.
Personality - Synergy 100
0. Trans PV
1. DSK Drop On
Manual
MENU
Exit 100
Previous SEL
Accept 10
Down
1
Up
2. SleepTime 10 min
3. Menu Bttn Menu Only
4. AutoRcall On
5. GPIO Mode Disabled
6. Show Knob 0
7. Audio Cut
On