Ross Synergy 100, Руководство по установке, Страница: 225 / 246

Synergy 100 Installation Guide (v16.10-S100) Appendix C. Diagnostics • 12–9
3. Calibrate the positioner as follows:
• Ensure the
0. Knob/Fader/Positioner Calibration
option is selected.
• Move each axis as follows:
~
X-Axis
— Calibrate the X-Axis by moving the joystick fully left and right.
Repeat this procedure two or three times.
~
Y-Axis
— Calibrate the Y-Axis by moving the joystick fully up and down.
Repeat this procedure two or three times.
~
Z-Axis
— Calibrate the Z-Axis by twisting the joystick knob fully clockwise
and counterclockwise. Repeat this procedure two or three times.
As you move the joystick, you will see a series of numbers appear in the
four-character displays in the
Effects Control and System Control groups.
• Calibration is complete when the limit values in these four-character displays no
longer change.
4. Calibrate the knobs as follows:
• Ensure the
0. Knob/Fader/Positioner Calibration
option is selected.
• Move each knob fully left and right.
• Repeat this procedure two or three times for each knob .
As you move the knobs, you will see a series of numbers appear in the
four-character displays
in the Effects Control and System Control groups.
• Calibration is complete when the limit values in these four-character displays no
longer change.
5. Adjust the brightness of all the LEDs on the control panel as follows:
• Press
1. Overall LED Brightness Control
.
• Brightness of all button and non-button (secret-til-lit and logo) LEDs is adjusted by
rotating
any knob on the panel.
6. Adjust the brightness of only the LEDs in the Ross logo in the upper right-hand corner of
the Synergy 100 control panel as follows:
• Press
2. Logo Brightness
.
• Brightness of these LEDs is adjusted by rotating any knob on the panel.
7. Adjust the brightness of only the LEDs under the panel buttons as follows:
• Select one of the buttons #3 through #5, as applicable.
• Brightness is adjusted by rotating any knob on the panel.
8. Adjust the brightness of only the LEDs under the secret-til-lit on-air and bus indicators
as follows:
• Select one of the buttons #6 through #8, as applicable.
• Brightness is adjusted by rotating any knob on the panel.
Note
The numbers for each axis may not match — this is normal.
Note
The numbers for each knob may not match — this is normal.