Ross Synergy 100, Руководство по установке, Страница: 157 / 246

Synergy 100 Installation Guide (v16.10-S100) Additional Installation Setups • 8–23
Setting up Frame GPIs
The Frame GPIs allow external devices to trigger certain transition functions in your switcher.
The Frame GPIs Setup Menu allows you to set up your 12 “standard” Frame GPI input ports.
During this setup, you will select a GPI input port and assign a Function and an Area of the switcher
that will be effected, when a GPI pulse is received. You will also identify the Polarity and Type of
the incoming GPI pulses. All 12 ports are provided on the GPI I/O connector on the rear of the
Synergy frame. Refer to the section “ Standard GPI Connections ” on page 8-26 for wiring
instructions.
Use the following procedure to set up Frame GPIs:
1. Navigate to the Frame GPI Setup Menu as follows:
• Press MENU to display the Main Menu .
• Press 3. GPIs to display the GPI Setup Menu .
GPIs Menu
2. Press 0. Frame GPIs to display the Frame GPIs Menu .
Frame GPIs Menu
Note
The Frame GPIs will not function unless they are enabled in the
Effects Menu . Refer to the section, “ Effects Functions ” in Chapter 8
of the Synergy 100 Operation Guide .
GPIs
0. Frame GPIs
1. Remote GPIs
MENU
Exit 100
Previous SEL
Accept 10
Down 1
Up
2. GPI Outputs
Frame GPIs
0. Input
1. Function GPI 1
Cut
2. Area
3. Polarity FTB
Low
4. Type Edge
MENU
Exit 100
Previous SEL
Accept 10
Down
1
Up