Ross Synergy 100, Руководство по установке, Страница: 40 / 246

2–6 • Installation Synergy 100 Installation Guide (v16.10-S100)
Control Panel, Rear Connector Panel
The following figure illustrates the rear connectors on the Synergy 100 control panel.
Synergy 100 Control Panel — Rear View, Connector Section
1. Power
One DC connector is provided to supply power to the control panel.
2. Analog Connector
One 50-pin connector labeled ANALOG is provided for those users who wish to use
their existing Ross RVS 210 or Ross RVS 216 control cable to connect their Synergy
100 panel to the frame.
3. 100/110 Connector
One 15-pin “D” connector labeled 100/110 is provided for those users who wish to use
their existing GVG 100/110 control cable to connect their Synergy 100 panel to the
frame.
4. Synergy Connector
One 8-pin shielded Telco connector labeled SYNERGY is provided for those users who
wish to use a Telco control cable (supplied) to connect their Synergy 100 panel to the
frame.
5. Tally Connectors
Two 12-pin connectors labeled TALLY 1 and TALLY 2 are provided for a total of 16
standard panel tally relays.
1) Power
2) Analog Connector 3) 100/110 Connector
4) Synergy Connector 5) Tally Connectors
Important
The cable for connecting the Synergy 100 Control Panel to the
Synergy 1 Frame is not wired as a standard CAT5 ethernet cable. If
you need a cable of a specific length, contact your Ross Video
Representative for ordering information.
A
NALOG
100/110
S
YNERGY
T
ALLY
1 T
ALLY
2
12V__
4A
-----
ROSS VIDEO LIMITED
MADE IN CANADA
Synergy 100
THIS CLASS A DEVICE COMPLIES WITH CANADIA
ICES-003 AND PART 15 OF THE FCC RULES.
OPERATION IS SUBJECT TO THE FOLLOWING CONDITIONS:
(1) THIS DEVICE MAY NOT
CAUSE HARMFUL INTERFERENCE
AND,
(2) THIS DEVICE MUST ACCEPT ANY
INTERFERENCE RECEIVED, INCLUDING
INTERFERENCE THAT MAY CAUSE
UNDESIRED OPERATION.
R
1 2 3 4 5