Ross Synergy 100, Руководство по установке, Страница: 116 / 246

7–16 • Communication Setup Synergy 100 Installation Guide (v16.10-S100)
n/c = Not connected
Use the following procedure to set up your Yamaha 01V audio mixer:
1. Press the MIDI function button to display the MIDI SETUP Menu . You may have to
press the MIDI button several times to cycle through the MIDI menus.
2. Use the Cursor buttons to navigate to the following:
• Tx PORT — Use the Parameter Dial to set this to MIDI .
• Rx PORT — Use the Parameter Dial to set this to MIDI .
• Tx CH — Use the Parameter Dial to set this to 1 .
• Rx CH — Use the Parameter Dial to set this to 1 .
• Use the following table to set the indicated parameters.
3. Press ENTER to save your changes.
Note For RS-232 cables, only pins 2, 3, and 5 should be connected. All other
pins must be disconnected.
Important True RS-232 is only available on Peripheral Port 2 . However, you
can connect an audio board using RS-232 protocol to Peripheral Port
1 if the Protocol heading is set to RS-422 , and an RS-422-to-RS-232
converter is used.
RS-422 Synergy-to-Yamaha 01V Wiring Chart
Synergy 1 Frame Yamaha 01V Panel
Peripheral 1-2
Connector Male
Signal TO HOST Port
Connector Male
Signal
1 n/c n/c
2 Tx- → 5 Rx-
3 Rx+ → 6 Tx+
4 Ground n/c
5 Ground
→
4 Ground
6 n/c n/c
7 Tx+ → 8 Rx+
8 Rx- → 3 Tx-
9 n/c
Yamaha 01V Setup
Tx Rx OMNI ECHO
Program Change ON ON OFF OFF
Control Change ON ON OFF OFF
Param Change ON ON -- OFF
Bulk -- OFF -- --