Ross Synergy 100, Руководство по установке, Страница: 55 / 246

Synergy 100 Installation Guide (v16.10-S100) Installation • 2–21
1. Reset Switch
Press the red
RESET
switch on the frame to initiate a full system reset. When the reset is
initiated from the frame, the control panel’s reset is initiated via a software message that
is passed along the RS-422 control cable. In the unlikely event that the control panel has
crashed, it may be necessary to
manually reset the control panel. Refer to the section
“ System Reset Notes ” on page 2-23 for additional information.
2. DIP Switch 1
This 8-position DIP switch is reserved for future use. Please leave all switches in the
default
Down
position, as labeled on the switch. (Early issue boards may find this
switch unpopulated).
3. DIP Switch 3
This 8- position DIP switch has the following system assignments (from left to right):
•
SW1 – SW7
– Reserved . Leave in the default
Down
position.
•
SW8 –
Squeeze & Tease 3D Software Upgrade . This switch controls the ability to
upgrade the Squeeze & Tease 3D software from a storage device:
~
Up
: Software can be upgraded from a storage device, such as a floppy disk or
USB key. Refer to Chapter 2 “ Installation and Setup ” in your Synergy 100
Squeeze & Tease 3D/WARP Owner’s Guide for instructions.
~
Down
: Software can not be upgraded from a storage device. This is the default
position.
4. DIP Switch 2
This 8-position DIP switch has the following system assignments (from left to right):
•
SW1
–
SW7
– Reserved . Leave in the default
Down
position.
•
SW8
– Preview Overlay . This switch controls the ability to remove the Preview
Overlay from the Preview outputs.
~
Up
: Preview Overlay is removed from the Preview output and is displayed on
Aux 1 and Aux 2 outputs.
~
Down
: Preview Overlay displays on PV1 and PV2 outputs. This is the default
position.
5. DIP Switch 4
This 8-position DIP switch has the following system assignments (from left to right):
•
SW1
– Reserved . Leave in the default
Down
position.
• SW2 – Reserved . Leave in the default Down position.
•
SW3
– Panel Type . Works with
SW4, SW5
and
SW6
.
•
SW4
– Panel Type . Works with
SW3, SW5
and
SW6
.
• SW5 – Panel Type . Works with SW3, SW4 and SW6 .
•
SW6
– Panel Type . Works with
SW3, SW4
and
SW5
.
Refer to the the section “ DIP Switch 4 Positions ” on page 2-22 for details.